The physical properties of honey vary, depending on water content, the type of flora used to produce it (pasturage), temperature, and the proportion of the specific sugars it contains. Fresh honey is a supersaturated liquid, containing more sugar than the water can typically dissolve at ambient temperatures. At room temperature, honey is a supercooled liquid, in which the glucose will precipitate into solid granules. This forms a semisolid solution of precipitated sugars in a solution of sugars and other ingredients.
The melting point of crystallized honey is between 40 and 50 °C (104 and 122 °F), depending on its composition. Below this temperature, honey can be either in a metastable state, meaning that it will not crystallize until a seed crystal is added, or, more often, it is in a "labile" state, being saturated with enough sugars to crystallize spontaneously. The rate of crystallization is affected by the ratio of the main sugars, fructose to glucose, as well as the dextrin content. Temperature also affects the rate of crystallization, which is fastest between 13 and 17 °C (55 and 63 °F). Below 5 °C, the honey will not crystallize and, thus, the original texture and flavor can be preserved indefinitely.
Since honey normally exists below its melting point, it is a supercooled liquid. At very low temperatures, honey will not freeze solid. Instead, as the temperatures become colder, the viscosity of honey increases. Like most viscous liquids, the honey will become thick and sluggish with decreasing temperature. While appearing or even feeling solid, it will continue to flow at very slow rates. Honey has a glass transition between -42 and -51 °C (-44 and -60 °F). Below this temperature, honey enters a glassy state and will become an amorphous solid (noncrystalline).
The viscosity of honey is affected greatly by both temperature and water content. The higher the humidity, the easier honey will flow. Above its melting point, however, water has little effect on viscosity. Aside from water content, the composition of honey also has little effect on viscosity, with the exception of a few types. At 25 °C (77 °F), honey with 14% humidity will generally have a viscosity of around 400 poise, while a honey containing 20% humidity will have a viscosity of around 20 poise. Viscosity increase due to temperature occurs very slowly at first. A honey containing 16% humidity, at 70 °C (158 °F), will have a viscosity of around 2 poise, while at 30 °C (86 °F), the viscosity will be around 70 poise. As cooling progresses, honey will become more viscous at an increasingly rapid rate, reaching 600 poise around 14 °C (57 °F). However, while honey is very viscous, it has rather low surface tension.
A few types of honey have unusual viscous properties. Honey from heather or manuka display thixotropic properties. These types of honey enter a gel-like state when motionless, but then liquify when stirred.
Since honey contains electrolytes, in the form of acids and minerals, it exhibits varying degrees of electrical conductivity. Measurements of the electrical conductivity are used to determine the quality of honey in terms of ash content.
The effect honey has on light is useful for determining the type and quality. Variations in the water content alter the refractive index of honey. Water content can easily be measured with a refractometer. Typically, the refractive index for honey will range from 1.504 at 13% humidity, to 1.474 at 25%. Honey also has an effect on polarized light, in that it will rotate the polarization plane. The fructose will give a negative rotation, while the glucose will give a positive one. The overall rotation can be used to measure the ratio of the mixture.
Honey has the ability to absorb moisture directly from the air, a phenomenon called hygroscopy. The amount of water the honey will absorb is dependent on the relative humidity of the air. This hygroscopic nature requires that honey be stored in sealed containers to prevent fermentation. Honey will tend to absorb more water in this manner than the individual sugars would allow on their own, which may be due to other ingredients it contains.
Like all sugar compounds, honey will caramelize if heated too much, becoming darker in color and eventually burning. However, honey contains fructose, which caramelizes at lower temperatures than the glucose. Honey also contains acids, which act as catalysts, decreasing the caramelization temperature even more. Of these acids, the amino acids, which occur in very small amounts, play an important role in the darkening of honey. The amino acids form darkened compounds called melanoidins, during a Maillard reaction. The temperature at which caramelization begins varies, depending on the composition, but is typically between 70 °C (158 °F) and 110 °C (230 °F). The Maillard reaction will occur slowly at room temperature, taking from a few to several months to show visible darkening, but will speed-up dramatically with increasing temperatures. However, the reaction can also be slowed by storing the honey at colder temperatures.
Unlike many other liquids, honey has very poor thermal conductivity, taking a long time to reach thermal equilibrium. Melting crystallized honey can easily result in localized caramelization if the heat source is too hot, or if it is not evenly distributed. However, honey will take substantially longer to liquify when just above the melting point than it will at elevated temperatures. Melting 20 kilograms of crystallized honey, at 40 °C (104 °F), can take up to 24 hours, while 50 kilograms may take twice as long. These times can be cut nearly in half by heating at 50 °C (122 °F). However, many of the minor substances in honey can be affected greatly by heating, changing the flavor, aroma, or other properties, so heating is usually done at the lowest temperature possible for the shortest amount of time.
Read more about this topic: Honey
“ Self-esteem is as important to our well-being as legs are to a table. It is essential for physical and mental health and for happiness. ”
—Louise Hart (20th century)
“ Whenever reality reinforces a childs fantasied dangers, the child will have more difficulty in overcoming them. So, while parents may not regard a spanking as a physical attack or an assault on a childs body, the child may regard it as such, and experience it as a confirmation of his fears that grown-ups under certain circumstances can really hurt you. ”
—Selma H. Fraiberg (20th century)
“ We do not want actions, but men; not a chemical drop of water, but rain; the spirit that sheds and showers actions, countless, endless actions. ”
—Ralph Waldo Emerson (18031882)
“ The reason why men enter into society, is the preservation of their property; and the end why they choose and authorize a legislative, is, that there may be laws made, and rules set, as guards and fences to the properties of all the members of the society: to limit the power, and moderate the dominion, of every part and member of the society. ”
—John Locke (16321704)